DELTASION.com – To be able to assemble a computer yourself is not difficult if we are thorough and willing to learn because actually how to assemble a computer is very easy. Then the process is also small and does not take a long time.
Currently there are lots of tutorials on assembling a gaming computer that you can find on the internet, but only a few articles actually provide the complete tutorial.
So, through this article, I will give you a way to assemble a PC that’s right for you, so take a good look, step-by-step.
Preparation To Assemble a Computer / PC
Before starting the assembly, there are some preparations that you must do, such as preparing:
- Screwdriver
- Tang
- Flat Base
- Cable Ties
- Scissors
- Manual Book
After preparing the tools above. You can immediately enter the PC assembly stage.
How to Build the Right Personal Computer with Pictures
Below is a tutorial on how to build a gaming computer for beginners with illustrations.
Motherboards & CPUs
The first step in tips on assembling a computer is placing the motherboard on top of the box so that there is no damage to the pins. After that, remove the CPU from the Box and insert it into the Processor Socket on the Motherboard.
Be careful when putting the processor into the socket, don’t make mistakes that can cause broken or bent pins. Gently place the processor into the socket in the right position, then attach the socket lock.
Install Cooler
Usually, to build a new computer, you will use the stock cooler that comes with the processor and is equipped with thermal paste. So, for those of you who use stock coolers from the after market, aka buying outside, you must use additional thermal paste.
After applying thermal paste to the Cooler, place the cooler above the processor in the correct position after that, lock the Cooler and don’t forget to plug in the Cooler power pin on the motherboard that says CPU FAN.
Install RAM
After finishing installing the Cooler on the Motherboard, then we will install RAM. Match the small hole in the RAM with the RAM slot on the Motherboard.
After that, press a little hard until it clicks, which indicates that the RAM is properly locked in the Motherboard Slot.
Install I/O Panel and Motherboard
The next correct step for assembling a computer is to install the I/O Panel and Motherboard into the Casing.
Do this step carefully and make sure the Motherboard is screwed in tight and snug.
Installing the Power Supply
The next way to assemble a computer is to install the PSU. You should know that the Power Supply is one of the important components in a PC because it is this hardware that will supply power to a computer.
After you finish installing the motherboard into the casing, you can immediately install the PSU into the casing and screw it tightly.
Install the Hard Disk Drive
After finishing installing the PSU into the casing, we can insert the HDD into the HDD slot on the casing. Don’t forget to lock it with a tight bolt.
Don’t forget to plug in the PSU Connector cable for the HDD.
Plug in the Power Cable
Power cables and other supporting cables are the most important steps in assembling a computer.
If you have finished installing the hardware into the casing, you can already install the power cable in the available slot and don’t insert the wrong cable.
Pay attention to the types of Pins that exist and look for a suitable location. You can consult the manual if confused at this stage.
Installing the Graphics Card
Finally, you can install a VGA card if you have one, don’t forget to plug in the PCIe power pin if needed.
Conclusion
After finishing installing all the components, you can immediately try to turn on the computer and see the results of your own PC assembly.
If the computer starts up normally then congratulations! You can set up your own computer properly.
That’s all for this article on how to assemble a computer CPU, I hope this is useful for all of you.